Using The Device With Spray Attachment; Cleaning/Maintenance - Parkside PKGA 12 A1 Traduction Des Instructions D'origine

GB IE
Using the device with
spray attachment
The tank can be fi lled with water or
water-soluble plant protection agents.
Please take notice of the safety in-
formation and instructions provided
by the manufacturer of the plant
protection agent. Wear the perso-
nal protective equipment recommen-
ded by the manufacturer.
Fill the tank before you attach the
spray attachment (13) onto the
device head (1).
Avoid operating the spray
attachment (13) while empty..
1. Open the tank cover (17) and fi ll the
spray attachment (13).
2. Close the tank cover (17).
3. Attach the spray attachment to the
device head (1). (See "Attaching/repla-
cing accessories")
4. You can regulate the spray attachment
by turning the nozzle (18).
Checking the level indicator:
Hold the spray attachment mounted
to the device head vertically. This
will allow you to read the markings
(MAX, 2/3 , 1/3 und MIN) and see the
fi ll level.

Cleaning/Maintenance

Leave any work not covered
in this manual to our Service
Centre. Only use original
parts. There is a risk of injury!
28
Remove the battery before all
maintenance work. There is a
risk of injury.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on the
unit.
Wear gloves when handling the
blades (
of injury from cuts!
Clean and service the unit regularly as fol-
lows. This guarantees a long life for your unit:
• Check the covers and guards for dam-
age and correct position. If necessary,
replace.
• Never operate the machine with defec-
tive guards or covers or without protec-
tion or with damaged or worn cables.
• Keep the ventilation slits, motor housing
and handles on the equipment clean. To
do this, use a damp cloth or brush.
• Always keep the blade clean.
After using the equipment, it is impera-
tive to:
- Clean the blade
(with an oily cloth);
- Oil the blade shaft
with an oil can or
spray.
• Slight notches on the
blades can be evened
out. For this, sand
down the blades with an oil stone.
Only sharp blades can cut properly.
• Blunt, bent or damaged blades must be
changed.
• Clean the spray attachment (
with clean water while wearing per-
sonal protective equipment (e.g. gloves,
safety googles).
10/12). There is a risk
13)