Dometic EK 1600 Notice D'utilisation page 11

Dometic EK 1600, EK 3200
If you don't use gimbals, mount the stove as follows:
➤ Fasten the hob in place using four screws.
Mount the gimbals as follows (fig. 5, page 4):
➤ Fasten the gimbal sideplates (1) to the lower body of the stove (3) using
the enclosed nuts and bolts.
NOTE
I
The gimbal arms (2) can be turned to enable the stove (3) to be
lowered forwards or backwards.
➤ Before mounting the gimbal arms (2), make a test by attaching them to
the gimbal sideplates (1) in order to determine which alternative is right
for your boat.
Ensure the installation is done according to fig. 5, page 4.
➤ Place the fibre washers (4) with round holes on the gimbal arms (2).
➤ Lift the stove into position.
➤ Place the fibre washers (5) with oblong holes on the gimbal sidearms (2).
➤ Fasten the screws (6).
➤ Adjust the tension of the screws to the desired friction.
6.3 Connecting the hob to the gas supply
WARNING! Risk of injury!
!
Only use propane or butane gas bottles with an approved pressure
reduction valve and suitable top part. Compare the pressure infor-
mation on the type plate with the pressure information on the pro-
pane or butane gas bottle.
Observe the following instructions during connection:
 Use gas lines made from steel ( 8 x 1 mm – welded, seamless or stain-
less steel), that are flush-mounted with a cutting ring screw assembly.
 Fasten the pipes on the side or rear wall of the surrounding furniture parts
so that no loads are exerted on the actuators.
 The connection must only be able to be released using tools. Observe the
technical regulations on DVGW worksheets G607 and G608.
 The entire pipe system must be free of stress.
EN
Installing the hob
11