Assembly - Muskoka 37-196-48 Guide D'utilisation Et D'entretien

Assembly

ATTACHING THE SUPPORT
LEG AND CONNECTORS
1. Locate the base panel (C) and place on a
soft surface to protect the finish. Line up and
insert the long connector (CC) on the support
leg (V) into the unthreaded holes in the
center of the base panel (C).
2. Attach the support leg (V) to the base panel
(C) by turning a bolt (AA) clockwise through
the long connector (CC). Do not strip the
bolt (AA) by overtightening.
3. Locate the top trim (M) and place them on a
soft surface to protect the finish.
4. Insert two short connectors (BB) into the top
trim (M) where indicated. Press down firmly
until flush.
5. Attach the short connectors (BB) by inserting
two bolts (AA) and turning clockwise. Do not
strip the bolts (AA) by overtightening.
ATTACHING THE FRONT AND BACK
PANELS TO THE BASE
1. Line up and insert two wood dowels (DD) into
the unthreaded holes in the side of the base
panel (C). Line up the wood dowels (DD) with
the unthreaded holes in the front apron panel
(L). Press together until flush.
2. Line up the short and long connectors (BB
& CC) in the base assembly (C) with the
unthreaded holes in the rear apron panel (K).
Press together until flush.
3. Insert five bolts (AA) into the short and long
connectors (BB & CC) on the base assembly.
4. Attach the front and rear apron panels (L &
K) by turning the bolts (AA) clockwise. Do not
strip the bolts (AA) by overtightening.
V
C
AA
CC
AA
BB
M
BB
AA
K
C
AA
CC
DD
L
5