Pre-Assembly; Planning Assembly; Tools Required - Muskoka 37-196-48 Guide D'utilisation Et D'entretien

Pre-Assembly

PLANNING ASSEMBLY

Before you begin assembly, locate the instructions and hardware. Compare all parts with the Hardware
Included and Package Contents lists. Be sure you have all the parts and can identify them. A helping hand is
always good. Assemble your mantel with an adult assistant if possible. Some pieces are heavy and will need to
be held by a helper. Assembly time will take approximately 30-60 minutes.
Before assembly, use scissors to unwrap the parts from the packaging. Do not use a box cutter or exacto-knife,
as you may cut into the mantel pieces inside the box and damage the finish. Check for the red hardware bag
located inside the packaging. Do not discard any pieces. Use an appropriate screwdriver to insert and tighten
all screws.

TOOLS REQUIRED

Safety
goggles
HARWARE INCLUDED
Note: Hardware not shown to actual size.
AA BB
HH JJ
Part Description
AA Bolt
BB Short Connector
CC Long Connector
DD Dowel
EE Knob
FF Back Panel Screw
GG Door Hinge Plate
(NOT INCLUDED)
Phillips
screwdriver
CC
KK LL
Quantity
33
2
2
36
2
30
4
DD EE
MM
Part Description
HH Shelf Pin
JJ Hinge Screw
KK Long Screw
LL Long Metal Bolt
MM Short Metal Bolt
NN Metal Cam Lock
FF GG
NN
Quantity
8
16
2
4
4
8
3