Muskoka 37-196-48 Guide D'utilisation Et D'entretien page 10

Assembly (continued)
PREPARING THE TOP PANEL
1. Locate the top panel (A) and place it on
a soft surface to protect the finish with
the finished side facing down.
2. Insert four long cam lock dowels (LL) into
the threaded holes in the sides of the top
panel (A) by turning clockwise. Do not
strip the long cam lock dowels (LL) by
overtightening.
3. Insert four short cam lock dowels (MM)
into the threaded holes in the front of the
top panel (A) by turning clockwise. Do
not strip the short cam lock dowels (MM)
by overtightening.
ATTACHING THE TOP PANEL
1. Insert four wood dowels (DD) into the
unthreaded holes in the top of the left and
right side panels (E & F). Line up the wood
dowels (DD) in the side panels (E & F) with
the unthreaded holes in the top panel (A).
2. Line up the long and short cam lock dowels
(LL & MM) with the cam lock holes in the
media console assembly. Push down on the
top panel (A) until flush.
3. Insert eight metal cam locks (NN) into the
cam lock holes in the left and right side
panels (E & F) and the top rail (J).
4. Attach the top panel (A) to the media
console assembly by turning the metal cam
locks (NN) clockwise. Do not break the
metal cam locks by overtightening.
5. Insert one bolt (AA) through the short
connector (BB) on the support piece (S) and
tighten by turning clockwise. Do not strip the
bolt (AA) by overtightening.
10
A
LL
A
J
S
B
F C
MM
DD
NN
E
BB
AA