General Characteristics - Cembre B51 Notice D'utilisation

ENGLISH
BATTERY OPERATED HYDRAULIC CRIMPING TOOL
B51 ; B51A

1. GENERAL CHARACTERISTICS

TOOL TYPE:
Application range: suitable for installing electrical compression connectors
Crimping force kN (sh ton):
Rated operating pressure bar (psi):
Dimensions LxWxH mm (inches):
Weight with battery kg (lbs):
Motor Volt DC:
Battery Volt / Ah:
Battery charger supply Volt / Hz:
Recommended oil: AGIP ARNICA 32 or SHELL TELLUS TX 32 or equivalent.
Operating speed:
Safety:
Operating temperature:
Acoustic noise (Directive 2006/42/EC, annexe 1, point 1.7.4.2 letter u)
– The weighted continuous acoustic pressure level equivalent
A at the work place L is equal to ................................................................................ 75 dB (A)
pA
– The maximum value of the weighted acoustic displacement
pressure C at the work place L is .................................................................... < 130 dB (C)
pCPeak
– The acoustic power level emitted by the machine
L is equal to ............................................................................................................ 85,3 dB (A)
WA
Risks due to vibration (Directive 2006/42/EC, annexe 1, point 2.2.1.1)
Tests carried out in compliance with the indications contained in UNI ENV 25349 and UNI EN 28662
part 1 st Standards, and under operating conditions much more severe than those normally found,
certify that the weighted root mean square in frequency of the acceleration the upper limbs
are exposed to for each biodynamic reference axis does not exceed 2.5 m/sec
This hydraulic tool is powered by a 14.4V battery.
The tool is quiet in operation with minimal vibration, balanced for optimum control, with light-
weight construction enabling it to be held in one hand while positioning the connector with
the other.
The residual battery capacity level is automatically displayed after every cycle.
B51 B51A
2
for conductors up to 240 mm (500 MCM)
50 (6)
600 (8,700)
297 x 94 x 302 (11.7 x 3.7 x 11.9)
3,7 (8.1) 4,0 (8.8)
14.4
14.4 / 3.0 Li-Ion 14.4 / 3.0 Ni-MH
220 - 240 / 50 - 60 120 / 50 - 60
the tool has a twin speed operation and automatically
switches from a rapid advancing speed of the ram
to a slower, more powerful crimping speed.
the tool is equipped with a maximum pressure valve.
-15°C to +40°C (+5°F to +104°F)
2
.
72
13
67
72
53
72
68
69
76
58
59
57
58
59
4 33
22
23
19
16
17
53
72
53
203
70
204
21
53
32
71
47
29
47
26
80
60
64
60
70
18
70
18
18
70
18
11
23
20
202
73
14
05
15