Connecting Your Radio; Operating Your Radio - Dab - Scansonic R3 Guide D'instructions

C o n n e ct i n g y our r adi o
01
Your radio is supplied with a Mains Adapter.
02 Place your radio on a flat surface
03 Insert the adapter plug into the DC socket on the back of your radio
04 Plug the adapter into the 230 volts mains socket outlet
Important:
The AC adapter should be disconnected from the mains supply and the radio when not in use.
The mains adapter is used as the means of connecting the radio to the mains supply, do not
connect the radio to the mains outlet socket in any other way.
Op e r a ti n g y our r adi o - DAB
01
Carefully extend the telescopic antenna.
02 Press the ON/OFF button to switch on radio, the display will show "welcome" and the radio will
come into DAB mode automatically.
03 First time the radio is used a QUICK SCAN will be carried out, if the radio has been used before
the last used station will be selected.
04 For a new QUICK scanning press TUNE button briefly.
05 For a FULL SCAN press TUNE button 2 seconds – new stations may become available and a
full scan is recommended regularly.
06 When scanning is complete the display indicate the number of found stations.
07 Press and hold 1-4 buttons to save favourite stations.
08 SIGNAL N/A in display is shown because of weak station signal or antenna removed.
09 If no stations are found after scanning the display will show NO STATIONS AVAILABLE and it
is nescessary to relocate the radio to a position giving better reception, or connect the radio to
your house antenna.
6
3