Yamaha WaveRunner GP1200R Manuel D'entretien page 400

HULL
HOOD
HANDLEBAR
SERVICE POINTS
Handlebar inspection
1. Inspect:
Handlebar
Bends/cracks/damage → Replace.
Handlebar switch inspection
Refer to "STARTING SYSTEM" in
chapter 7.
Handlebar assembly installation
1. Adjust:
QSTS cable length a
QSTS cable length:
77 ± 0.5 mm (3.03 ± 0.02 in)
NOTE:
Before adjusting the QSTS cables, set the
control grip to the neutral position.
Adjust the QSTS cable lengths a to the
specified length and be sure to take up
any slack.
2. Install:
Upper handlebar holder 1
NOTE:
Align the punch marks a on the handle-
bar with the top surface of the handlebar
holder.
The upper handlebar holder should be
installed with the punch mark b facing
forward.
CAUTION:
Clearance c should be narrower than
clearance d.
8-7
E