Filling The Water Tank; Plugging In And Ironing - SilverCrest SDBR 420 A2 Mode D'emploi

Filling the water tank

1) Place the iron on a level surface.
2) Open the cover on the water tank 1 filler opening.
3) Fill the measuring cup w up to the MAX marking with tap water
and fill this water into the water tank.
4) Close the cover on the water tank 1 filler opening.
5) Raise the iron vertically. You can read off the maximum water
level at the inspection openings 2.

Plugging in and ironing

Dry ironing without steam is possible at all temperatures; steam
ironing is only possible above the setting range
temperature control 4.
1) Insert the plug into a mains power socket.
CAUTION! PROPERTY DAMAGE!
► Before you connect the steam iron to the power supply, always
ensure that the correct voltage has been set on the voltage
switch 7 (see section Before first use).
► If the clothing care instructions forbid ironing (
ment may not be ironed. Ignoring this warning could lead to
permanent damage to the clothing item.
2) Check the care instructions on the garment labels to see if they
are suitable for being ironed and at which temperature setting.
Temperature control symbol 4
SDBR 420 A2
/MAX on the
), the gar-
Material type
Silk, acrylic, rayon
Wool
Cotton, linen
GB │ IE │
11 ■