Observe The Following Instructions - Bosch REXROTH 3 842 998 350 Mode D'emploi

3 842 542 071/2013-10 | MPS
2.5

Observe the following instructions

2.5.1 General instructions
Observe the regulations for accident prevention and environmental
protection for the country where the product is used and at the workplace.
Exclusively use Rexroth products in good technical order and condition.
Check the product for visible defects.
Only use the product within the performance range provided in the
technical data.
Persons who assemble, operate, or disassemble Rexroth products must not
consume any alcohol, drugs, or pharmaceuticals that may affect their ability
to respond.
Make sure that all safety equipment belonging to the product is present,
has been installed properly, and is fully functional. Do not displace, bypass,
or disable the safety equipment.
If it should be necessary to disable any safety equipment temporarily,
for example for commissioning or maintenance work, always take the
appropriate measures to prevent situations that could endanger persons
or property. Also observe the superordinate operating instructions of the
machine or system.
Do not expose the product to any mechanical loads under any
circumstances.
Liability: In no event can the manufacturer accept warranty claims or
liability claims for damages arising from improper use of the appliance
or from intervention in the appliance other than that described in these
instructions.
Warranty: The manufacturer can accept no warranty claims arising from the
use of non-original spare parts! MTparts spare parts list: 3 842 529 770
Environmental protection: Always dispose of parts in the correct manner
when replacing parts.
2.5.2 During transport
Observe the transport instructions on the packaging.
2.5.3 During assembly
Make sure the relevant system component is not under pressure or voltage
before assembling the product or when connecting and disconnecting
plugs. Protect the system against being switched on.
Lay cables and lines so that they cannot be damaged and no one can trip
over them.
2.5.4 During commissioning
Let the product acclimate itself for several hours before commissioning,
otherwise water may condense in the housing.
Make sure that all electrical/pneumatic connections are either used or
covered. Commission the product only if it is installed completely.
2.5.5 During operation
Only allow persons who are authorized by the operator to access the
system's direct operating area. This is also valid when the system is
standing still.
In case of an emergency, fault, or any other anomalies, switch the system
off and protect it against being switched on again.
Bosch Rexroth AG 7/30
DE
EN
FR
IT
ES
PT