SC iKonn 220 Mode D'emploi page 59

SC iKonn 220 - Selection & Operating of the Modes
Lock / Unlock Resistance in TC / TCR Mode
In TC and TCR mode, when the device is powered on, keep pressing the Fire button and the Up button simulta-
neously for two seconds to lock or unlock the atomizer heads "base resistance"� The lock sign will appear when
resistance is locked and "Ω" symbol will come back when unlocked�
Note:
1� This function should only be used at room temperature, to ensure that the correct "base resistance" is locked�
2� When you remove the coil and then put it back while in resistance lock mode, the device can maintain the same
"base resistance" although the coil resistance may increase due to the rise of temperature� When you remove the
coil and then put a coil back while in resistance unlock mode, the screen may display "NEW COIL RIGHT, SAME
COIL LEFT"� If it is the same coil, press the left adjustment button and if it is a new coil, press the right adjustment
button� When changing atomizer heads, be sure to unlock the resistance so the base resistance matches the new
coil�
3� If you accidentally use a conventional coil or coils with a resistance greater than 1�5 ohms in TC-Ni, TC-Ti, TC-SS or
TCR (M1, M2, M3) modes, the device will automatically switch to VW Mode�
Adjusting the Wattage in TC/TCR Mode
In TC and TCR modes, the output power is between 1 and 220 watts� Press the Fire button quickly 4 times to adjust
the wattage� Use the "Up" or "Down" buttons to set the wattage�
57