aldes VMC double flux Dee Fly Notice De Montage page 33

ASSEMBLY
Bypass
(optional)
BUS
1 2 3
SAFETY INSTRUCTIONS
Assembly precautions
• 230V–50Hz single-phase power supply
• Connections to the electrical mains should be
fitted by a qualified professional in accordance
with the rules laid down in NF C 15-100 or in
Disconnect the electrical
supply before any compliance with applicable regulations in the
operations and ensure
country of installation. A contact-breaking
that the unit cannot
device with a separation of at least 3 mm should
be started
be used on each pole.
accidentally.
• The electrical connections must use flexible
cabling which must have a cross section at least
equal to that of H05VV-F or H05RR-F.
• If the supply cable is damaged it must be
replaced, by a professional, with a cable of the
Never operate same reference, respecting the rules of NF C
on the electrical unit
15-100.
when the unit
is running
Power supply
Battery
230 V - 50 Hz
Heater
Protection
(accessoir)
3 or 10 A
2 3
N L E N L E N L
L = live
E = Earth
Precautions prior to starting up
• When starting up, all ductwork, including
exhausts and fresh air inlets, must be connected
correctly.
• Never place your hands in front of in inlet or
outlet orifice.
33
Configuring the product using the
switches
Switch no1: defrosting management
Use of the Dee Fly without the pre-
heating battery: the switch must be
in the off
position
Use of the Dee Fly with the pre-heating
battery:
- Off position: defrosting by unbalanc-
ing the extraction/fresh air flows.
- On position: defrosting without
unbalancing the extraction/fresh
air flows.
Switch no 2 : by-pass management:
- Off position: automatic open/close
(it is possible to open/close manual-
ly but the automatic mode switches
back after 3 hours)
- On position: manual open/close.
No timer.