Assembly; Delivery Content; Safety Fence; Worktable - HOLZMANN MASCHINEN BT 46 Mode D'emploi

13

ASSEMBLY

13.1 Delivery content

The machine is delivered pre-assembled.
For transport reasons, some parts of the machine can be assembled by the customer.
Machine
Fence
Hex-nut-driver
User manual
Operating tools
Check right after receiving the machine, whether all parts according to the parts list are complete and
without damage. Each visible defect and in particular wrong amounts and transport damages must be
clearly noted on the delivery documents, otherwise the goods shall be considered as taken over and
fully accepted under the sole responsibility of the customer.
13.2 Assembly

13.2.1 Safety fence

Fasten the safety fence (fig.a) with the hex screw M6x1.0-14, the lock washer and the flat
washer. Place the safety fence about 3mm over the sanding belt to ensure a free run.

13.2.2 Worktable

Fasten the worktabel with three hex screws M6x1.0-14 on the table support (fig.b). Next fix the
worktable with the screw and the washer at the machine (fig.c).
To avoid the trapping of fingers or workpieces between table and grinding wheel, the distance
between table and grinding wheel may be max.2mm!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
BT46
Table
Table support
Safety fence
Sanding belt and disc
Screws
ASSEMBLY
max. 2mm
29
BT 46