Technical Data; Assembly Instructions - LAS 11807 Manuel De L'opérateur

TOWBAR RACK
CONTENTS
TECHNICAL DATA
ASSEMBLY INSTRUCTIONS
U-BOLT FASTENINGS
FASTEN BICYCLES ON THE DRAWBAR CARRIER
EXPLODED VIEW
CONTACT INFORMATION
WARNING
Please read the operating instructions carefully prior to use and observe all safety instructions!
Retain the original packaging, the proof of purchase as well as these instructions for subsequent reference! When passing on
the rack, please include these operating instructions as well. Not observing such may lead to personal injury, damage to the
device or to your property! Please check content of package for integrity and completeness prior to use!
Before you start with the mounting process, check completeness of the drawbar carrier and read assembly instructions carefully. It is vital to follow the safety
instructions. Please keep in mind that some parts listed on the parts list are already pre-assembled. Technical subject to change.

TECHNICAL DATA:

Max. loading capacity: 35 kg

ASSEMBLY INSTRUCTIONS

REQUIRED PARTS
Wheel rails
Wheel rail end caps
Start with the preparation of the wheel rails. Shove 2 slot nut screws M6 x 50 each into the link under the wheel rail. At 2 rails insert 1 belt guide and at the both
other rails 2 belt guides also in the link.
Put the wheel rail end caps on both ends of the wheel rails. Now position the wheel rails on the basic frame and slide the thread of the slot nut screws into the
provided boreholes of the basic frame and secure them with the 6 mm washers and the plastic toggle nuts. Please consider, that 1 wheel rail each with one,
respectively with 2 belt guides make one wheel unit. (2 belts for the front wheel and one for the rear wheel) The belt guides point to the outsides. The wheel rails
can be adjusted easily after loosening the toggle nuts.
8
Dead weight: approx. 6 kg
Wheel rail fastenings
Basic frame
Picture 1
Belt guides
8
8
9
10
12
12