Obstacle Detection Functioning; Declaration Of Conformity - Erreka AM600S Manuel De L'installateur

4

OBSTACLE DETECTION FUNCTIONING

The gate can detect an obstacle in two ways:
A- Detection by photocell or safety strip
Opening safety device (SG.A)
During opening
If, during opening, the opening safety device (SG.A) is
enabled, the gate inverts operation direction and
slightly closes. The gate remains on standby until a key
command is received.
During closing
The opening safety device (SG.A.) does not run.
B- Direct detection (built-in safety) (DIP7=ON)
During opening
If, during opening, the gate collides with an obstacle,
the gate inverts the operation direction and gently
closes, remaining on standby until a new key command
is received.
5

DECLARATION OF CONFORMITY

Erreka Automatismos declares that the AM600S and
AM606S control boards have been designed for use in
a machine or for assembly along with other elements in
order to form a machine in line with Directive 2006/42/EC.
AM600S and AM606S control boards allow for
installations in line with Standards EN13241-1 and
EN12453, provided any necessary additional safety
devices are installed in accordance with the specific
installation (type of use, user qualification, location,
etc). It is the installer's responsibility to choose the
necessary devices (photocells, safety strips, etc).
DESCRIPTION OF THE PRODUCT
Closing safety device (SG.C)
During opening
The closing safety device (SG.C.) does not run.
During closing
If, during closing, the closing safety device (SG.C) is
enabled, the gate inverts operation direction and opens
completely.
During closing
If, during closing, the gate collides with an obstacle, it
inverts operation direction and opens completely.
AM600S and AM606S control boards comply with
safety legislation, in line with the following directives
and standards:
• 2006/95/EC (low voltage materials)
• 2004/108/EC (electromagnetic compatibility)
• EN 60335-1
Control board AM600S-AM606S
21