Electrolux EXI09HD1W Manuel D'installation page 19

caution
After tightening the screws, pull the wire
Do not connect two power cables
together to supply power to the air
conditioner.
by cutting.
Installation of Outdoor
Electric Wires
1 Remove the handle on the right side plate of
outdoor unit by loosening the screw.
Handle
2 Take off wire cable clamp. Connect and
screw the power connection cable and signal
control wire (for heap pump model only) onto
the terminal block following corresponding
terminal blocks of indoor and outdoor units.
3 To prevent water from entering, make a trap
("U") in the connection wires (see page 16).
4 Wrap wires that are not connected with
insulating tape so that they do not touch any
electrical or metal parts.
5
clamps.
6 Reinstall the handle.
2600~5275W, Heat Pump models
6450W, Heat Pump models
Terminal
block
Handle Handle
2
N(1)
yellow-
yellow-
blue black
green
green
blue
Indoor unit connection
indoor unit connection
Handle Handle
2
N(1)
yellow-
yellow-
blue black
green
green blue black
Indoor unit connection
indoor unit connection
3
brown
brown
black
3
brown
brown
19