Operation; Requirements At The Place Of Use; Setting Up The Charger; Charging The Batteries - Heiniger Xplorer Mode D'emploi

7 Operation

7.1 Requirements at the place of use

• Observe the manual (see chapter Specifications).
• Outdoor electrical sockets must be fitted with a residual current device (RCD).
• The work place must have adequate lighting.
• The electrical socket must be easily accessible so that the device can be quickly discon-
nected from the mains.
• It must be used beyond the reach of children.
• The charger's power cord must not be taut or kinked.
• Make sure there is adequate ventilation.

7.2 Setting up the charger

‹
2 ‹
‹
3
‹
1
Abb. 3

7.3 Charging the batteries

‹
‹
1
Abb. 4
34
Position the charger (1) on a fixed, level, dry
and clean surface.
Connect the AC adapter (2) to the charger.
Plug the AC adapter into the power socket.
The continuous green light on the lower LED
(3) signals that the AC adapter is correctly
plugged into the power socket and the charger
is supplied with power. The charger is ready to
operate (see also Chapter 7.4).
Press both sides of the battery latch (1) and
remove the battery.
Check the battery terminals for foreign objects
and dirt.
Cattle and Horse Clipper
‹
Abb. 5
‹
Abb. 6
‹
1
Abb. 7
Cattle and Horse Clipper
Without applying force, insert the battery from
above into the designated charging bay on the
charger.
The battery is charged. The status of the
charging process is displayed using LEDs (see
also chapter 7.4). As soon as the battery has
finished charging, all LEDs change from red
to green and the charger switches to "trickle
charging".
Push the charged battery into the clipper until
the battery latch (1) engages on both sides.
35