Initial.operation; Assembly; Mains Connection; Setting Up - FLORABEST FHA 1100 B2 Traduction Du Mode D'emploi D'origine

GB
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• The cross-section of mains connection
lines must be no smaller than rub-
ber hose lines with the designation
H07RN-F. The line must be 10 m long.
Initial Operation

Assembly

C
• Fix the carrying handle (9) to the
domestic water pump using the fixing
screws (10).
• To permanently install the home wa-
ter dispenser, screw it to the ground.
Screwing it to a fixing panel will pre-
vent the appliance from moving.
Mind not to obstruct the access to the
draining screw (13).

Mains Connection

The pump you have purchases is already
fitted with an earthed plug. The pump is in-
tended for connection to an earthed socket
at 230 V ~ 50Hz.

Setting up

• Place the unit on a firm, horizontal,
non-flooding surface.
• Always put up the home water dis-
penser at a point higher than the water
surface you wish to pump water from.
Where this is impossible, install a low
pressure-resistant shut-off implement
between the appliance and the suction
hose (Available from specialist retail-
ers).
• Remove the protective cap (5) from the
domestic water pump water outlet (6).
Fit the connecting piece (12) to the do-
mestic water pump water outlet (6).
38
• Remove the protective cap (14) from
the automatic switch water inlet (15).
Fit the automatic switch (20) to the con-
necting piece 12).

Connecting the hoses

On the suction side, attach a hose
with reflow stopper and install a
prefilter (Available from specialist
retailers). On the suction side, do
not use any quick-action connection
systems.
All screw connections must be fitted
with a sealing strip if the domestic
water pump is used inside the
house.
• Remove the protective cap (3) from the
domestic water pump water inlet (4). Fill
the suction line with water (please con-
tinue to fill the suction line with water until
all of the air has escaped). Fit the suction
line to the domestic water pump water
inlet (4).
• Remove the protective cap (2) from the
automatic switch water outlet (1).
Attach a pressure hose to the automatic
switch's water outlet fitting (
Air in the suction hose will stop
the house water dispenser from
working properly. Observe the
directions in the chapter "Filling the
Pump".

Filling the pump

Fill up the house water dispenser every
time before you start using it. This will en-
sure an immediate start. Running dry will
destroy the pump.
• Open the filling screw (11) on the do-
mestic water pump.
A
1).