Device Description / Spare Parts; Commissioning - ATIKA HA 550/58 Notice Originale

have been instructed by such a person on the use of the
device.
Supervise children to make sure they do not play with the
device.
Safe working
• Do not modify the device or parts of the device respectively.
• The operator is responsible to third persons within the area
of operations.
• Adhere to national regulations that might specify an age limit
for the user of the unit.
• Stop the hedge trimmer when moving to another work place.
• Always hold the hedge trimmer with both hands - one hand
on the front handle and the other on the rear handle.
• Make sure that you can step back safely without hindrances.
• Before trimming, remove all foreign objects (e.g. stones,
branches, wires, etc.). While working watch out for further
foreign objects.
• Be sure that the cutting tool already moves before you start
cutting.
• Caution! The cutting tool stops delayed after the machine is
switched off. Do not try to slow down the cutting tool by the
hand.
• After a longer period of use, accessible metallic parts and
accessories may be hot.
• Turn off the machine, remove the battery and wait until the
cutting tool is stationary when
− the cutting tool comes into contact with soil, stones, nails
or other foreign objects (
tool/machine is damaged)
− removal of faults (including blocking of knives)Leaving
the machine (also during temporary interruption)
• Maintain your hedge trimmer with care:
− Before each starting of the machine the safety devices
must be checked carefully for their proper and intended
function. Do not modify things on the machine that could
impair its safety.
− Damaged or illegible safety warning labels should be
replaced immediately.
Repairs to other parts of the machine must be carried out
by the manufacturer or one of his customer service
points.
Use only original spare parts, accessories and special
accessory parts. Accidents can arise for the user through
the use of other spare parts. The manufacturer is not
liable for any damage or injury resulting from such action.
check whether the cutting
Description / Spare parts
Pos. Bezeichnung
1
Knife
2
Cover strip
3
Hand guard
4
Front handhold with switch button
5
Rear handhold with ON- OFF switch
6
Extension
7
Cable strain relief
8
Cable with power plug
9
ON- OFF switch
10
Unlocking switch
11
Ventilation slots
12
Knife protection
13
Safety label

Commissioning

Mains connection
Compare the voltage given on the machine model plate e.g.
230 V with the mains voltage and connect the hedge trimmer to
the relevant and properly earthed plug.
Alternating current motor:
Use a shockproof plug, mains voltage 230 V with
residual current circuit breaker 30 mA and 10 A fuses.
Use connection cable or extension cable respectively with a
cross section of at least 1.5 mm².
Mounting of the extension cable
Plug the female connector of the extension cable on the
male connector of the switch-connector combination.
Thread the extension cable through the strain relief (7) as a
loop and hang it up.
Make sure that the extension cable has enough free motion.
Switch on
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
The hedge shears has a two-hand protective shut-down which
prevents an unintended switching on.
Push the circuit closer/breaker on the rear handhold
(5) and operate at the same time with the other hand the
switch button on the front handhold (4).
Bestell.-Nr.
364208
380950
364207
364190
15