Dräger CPS 5900 Training Notice D'utilisation page 9

4 Cleaning and disinfection
CAUTION
!
Do not use any solvents (e.g. acetone, alcohol) or
cleaning agents containing abrasive particles for
cleaning and disinfecting. Only apply the described
procedures and use the specified cleaning agents and
disinfectants. Other agents, dosages and contact
times may damage the product.
For information about suitable cleaning agents and
disinfectants and their specifications, refer to
document 9100081 at www.draeger.com/IFU.
1. Prepare a cleaning solution containing water and a
cleaning agent.
2. Clean all parts using a soft cloth and the cleaning solution.
3. Thoroughly rinse all parts under running water.
4. Prepare a disinfectant bath containing water and a
disinfectant.
5. Put the training suit into the disinfection bath.
6. Thoroughly rinse all parts under running water.
7. Remove any excess liquid from the training suit, e.g. with a
sponge, before drying.
8. Dry the training suit.
CAUTION
!
The training suit may not be tumble-dried.
The training suit must be completely dried to prevent
the formation of mold.
9. Allow the inside and outside of all parts to air-dry (tempera-
ture: max. 40 °C). Keep out of direct sunlight.
The training suit can be dried by blowing with dry, oil-free
compressed air or in a suit-drying cabinet:
Maximum temperature: 40 °C (104 °F)

Minimum drying time: 120 minutes

Dräger CPS 5900 Training
5 Storage
Close the fastener system up to approx. 5 cm from the end

stop.
Regularly check whether the fastener system is adequately

greased.
Store the training suit in a cool, dry, dark and airy place

without pressure or stress. Keep out of UV light and direct
sunlight; avoid ozone. Observe permitted storage tempera-
ture (see "Technical data" on Page 10).
Follow ISO 2230 and national regulations for storage,

maintenance and cleaning of rubber products.
Carefully fold up the depressurized training suit:

Do not crease suit material, visor, seams and fastener

system.
Lay sleeves across the chest part.

Roll up the trouser legs and place them on the sleeves.

Lay head of suit across rolled-up trouser legs.

Place the training suit inside carrier bag and store in the ap-

propriate storage compartment or lay flat in a textile-lined
bay. Avoid wear caused by constant friction against the
storage surface.
CAUTION
!
The training suit may be damaged if you fail to ensure
proper storage conditions!
6 Disposal
6.1 Service life
The training suit can be used as long as it continues to fulfill its
practical purposes.
6.2 Notes on disposal
The training suit must be disposed of in accordance with the
applicable waste disposal regulations.
Cleaning and disinfection
9