Sharp PS-919 Mode D'emploi page 4

4
Battery warning!
• The battery used in this product may present a risk of fi re or chemical
burn if mistreated.
• Do not attempt to open the product to replace the battery, it is not
designed to be changed.
• Dispose of batteries according to local regulations. Please recycle when
possible. Do not dispose as household waste or in a fi re as they may
explode.
• Batteries may explode if damaged.
• Charge the battery using the supplied charger only and follow the
instructions detailed in this manual. Charging the battery under any
other conditions may cause the battery to overhead, emit hydrogen gas,
leak, ignite or burst.
CAUTION!
1. Important safety considerations
• Do not expose batteries to high temperatures and do not place them on
locations where the temperature might increase quickly, e.g. near the
fi re or on the direct sunshine.
• Do not expose batteries to excessive radiant heat, do not throw them
into the fi re, do not disassemble them and do not try to recharge un-
rechargeable batteries. They could leak or explode.
2. To prevent deterioration or damage to the battery
• Do not drop or subject to strong physical shock.
3. To ensure long battery life
• Do not discharge completely.
How to remove the battery for disposal
RISK OF INJURY. WEAR GLOVES WHEN WORKING!
The battery should be removed by an authorized Sharp service centre.
Not doing so will invalidate any guarantees and warranties on your
device.
1. Remove the metal speaker grille on the front of the unit by gently prising
it off with a fl at head screwdriver.
2. Remove the 7 rubber screw covers on the front of the unit and unscrew
the screws using a Philips screwdriver.
3. Remove 1 screw from the bottom of the front half of the cabinet.
4. Open the main casing.
5. Locate the circuit board on the back part of the cabinet.
6. Remove the 4 screws in the corners of the circuit board which are
holding it in place. Lift the circuit board out carefully.
7. Disconnect the battery pack connector from the circuit board.
8. Gently pull the battery pack away from the circuit board by peeling it off
the adhesive pad holding it in place.
Disposal of this equipment and Batteries
• Do not dispose of this product or its batteries as unsorted
municipal waste. Return it to a designated collection point
for the recycling of WEEE in accordance with local law. By
doing so, you will help to conserve resources and protect
the environment.
• Most of the EU countries regulate the disposal of batteries
by law. Contact your retailer or local authorities for more information.
• The shown above appears on electrical and electronivcal equipment
and batteries (or the packaging) to remind users of this. If "Hg" or 'Pb'
appears below the symbol, this mean that the battery cantains traces of
mercury (Hg) or lead (Pb), respectively.
• Users are requested to use existing return facilities for used equipment
and batteries.
CE and UKCA statement:
• Hereby, Sharp Consumer Electronics Poland sp. z o.o. declares that
this audio device is in compliance with the essential requirements and
other relevant provisions of RED Directive 2014/53/EU and UK Radio
Equipment Regulations 2017.
• The full text of the EU declaration of conformity is available by following
the link www.sharpconsumer.com and then entering download section
of your model and choosing "CE Statements".