Telcoma Automations T400 Instructions Pour L'installation page 46

GB
TAB. 2
FUNCTION n. Dip OFF ON DESCRIPTION
Step-by-step
input
1
and
2
radio channel
mode (CH1)
3
Jolly
input mode
4
5
Re-closure timer 6
Photo test 7
Motor brake 8
9
US1 output
mode
10
N.C. 11
Reclosing after
the photoelectric 12
cells
46
During opening, upon pressing the P/Pbutton the gate stops, pressing it
again the gate closes.
Open - Stop - Close
During closing, upon pressing the P/Pbutton the gate stops, pressing it
again the gate opens.
During opening, upon pressing the P/Pbutton the gate stops for a few
seconds and then closes.
Open - Close
During closing, upon pressing the P/Pbutton the gate stops for a few
seconds and then opens.
During opening, pressing the P/Pbutton has no effect. During the pause,
"Apartment block" pressing the P/Pbutton has no effect.
always open During closing, upon pressing the P/Pbutton the gate stops for a few
seconds and then opens.
During opening, pressing the P/Pbutton has no effect. During the pause,
Open-Close with
upon pressing the P/Pbutton the gate closes.
inversion disabled
During closing, upon pressing the P/Pbutton the gate stops for a few
during opening
seconds and then opens.
Temporary block of manoeuvre during opening phase
Photocell 2 Inverts travel during closing
Connect this input to common if not used.
Opening with timer Timer input; closes the gate when the contact is opened and keeps
(external) automation open when contact is closed.
Timer input; closes the gate when the contact is opened and starts
Pedestrian opening pedestrian opening when contact is closed. With an S/S command and
with timer (external) gate open with pedestrian timer, the gate opens completely, closes
completely and re-opens to the pedestrian clearance.
Input for SLAVE This option of the Jolly input serves to connect two T400 with synchronised
commands commands.
Cut out
Connected
After one complete opening, the control unit only closes again with a
Cut out
manual control.
After one complete opening, the control unit closes automatically after the
Connected
programmed pause time.
Cut out See text at page 42.
Connected See text at page 42.
Cut out Function bypassed
The control unit completes a short manoeuvre in the opposite direction to
Connected compensate for motor inertia. Active with the STOP and LIMIT SWITCH
commands.
Contact for courtesy This mode enables control of a courtesy light. Lit from start of cycle to 2
light minutes after closing.
Contact for electric Contact to control an electric lock with external power supply unit. Active
lock for 3 seconds on each start of opening.
This contact indicates the gate status. The relay is activated at the start of
Status contact or
opening and turns off only when closing is complete. When electric limit
contact for gate open
indicator
active (open).
Blinker contact for
using the two N.C. and N.O. contacts.
Cut out Function bypassed
The activation of photoelectric cell reduces the pause time for whatever
Connected
is value previously was to 2 seconds.
NOTE