Makita M3601 Manuel D'instruction page 4

SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.
Adjusting the depth of cut
1. Place the tool on a flat surface. Loosen the screw
securing the stopper pole.
1
2
Fig.1
► 1. Stopper pole 2. Screw
2. Loosen the lock lever and lower the tool body until
the router bit just touches the flat surface. Tighten the
lock lever to lock the tool body.
Fig.2
► 1. Lock lever 2. Screw
3. Lower the stopper pole until it makes contact with
the adjusting hex bolt. Align the depth pointer with the
"0" graduation.
1
2
3
4
5
Fig.3
► 1. Depth pointer 2. Screw 3. Stopper pole
4. Adjusting hex bolt 5. Stopper block
4. Raise the stopper pole until the desired depth
of cut is obtained. The depth of cut is indicated on the
scale (1 mm per graduation) by the depth pointer. Then
tighten the screw to secure the stopper pole.
5. Your predetermined depth of cut can be obtained
by loosening the lock lever and then lowering the tool
body until the stopper pole makes contact with the
adjusting hex bolt.
CAUTION:
Since excessive cutting may cause
overload of the motor or difficulty in controlling
the tool, the depth of cut should not be more than
15 mm (9/16") at a pass when cutting grooves
with an 8 mm (5/16") diameter bit.
CAUTION:
When cutting grooves with a 20
mm (13/16") diameter bit, the depth of cut should
not be more than 5 mm (3/16") at a pass.
CAUTION:
When you wish to cut grooves
more than 15 mm (9/16") deep with an 8 mm
(5/16") diameter bit or more than 5 mm (3/16")
deep with a 20 mm (13/16") diameter bit, make
several passes with progressively deeper bit
settings.
4 ENGLISH
1
2