Electronic Sensor System; Wand Operation - Tennant V-HDU-14 Manuel Opérateur

OPERATION
EN

ELECTRONIC SENSOR SYSTEM

The machine's Electronic Sensor System monitors the
condition of the machine while operating. The sensor
light, located on the bag compartment lid (Figure 10),
will indicate the following conditions:
Green Light = Machine Functioning Properly.
Blinking Orange Light = Full Bag or Air
Obstruction. Replace bag or remove air obstruction
in vacuum hose.
Blinking Red Light = Brush Obstruction or Brush
Height set too low (Amp. overload). Remove brush
obstruction or readjust brush height.
FIG. 10
To reset sensor system, turn power switch off and then
back on again.
NOTE: The vacuum motor is also protected by an
internal thermal overload sensor. If motor temperature
gets too high, the thermal sensor will shut off motor.
Sensor will automatically reset when motor cools.
8
Home Find... Go To..

WAND OPERATION

The machine is equipped with a "ready to use" wand
and crevice tool.
Contact local distributor for Optional Tool Kit #604802
Kit includes: Upholstery Tool and Dusting Brush.
1. Stand machine upright. When upright, the power to
the brush motor automatically shuts off.
ATTENTION: When using the wand, keep machine
upright to prevent possible carpet damage.
2. Detach wand from retainer clip and attach crevice
tool located on carrying handle (Figure 11).
FIG. 11
3. Activate ON/OFF switch.
WARNING: Do Not Pick Up Flammable Or
Toxic Materials, Burning Or Smoking Debris.
The wand's hose expands up to 2.4m (8 ft) in reach
(Figure 12)
FIG. 12
V- -HDU- -14 / V- -HDU- -36 (04- -10)