Lavorwash ETNA 4000 Mode D'emploi page 19

FOAM CLEANING
(only FOAM)
32 Connect the device to a minimum 5 bar
air compressor (not supplied).
33 Using specific detergents is indispensa-
ble for foam production.
• Insert the compressed air fitting hose in V1
(hose not supplied).
• Adjust the air pressure from 2 to 5 bar with
knob V3.
• Fit the most suitable accessory in the handle
of the flexible hose L.
• Connect the device to a suitable electrical
outlet.
• Start by pressing main switch B.
• Selection switch P1 to the air position
AIR (II)
• Selection switch P to position
(I) detergent.
• For foam outflow, press lever L3
• Distribute the foam.
• Leave the detergent on for 1 minute.
• Vacuum by pressing button L1
• To select the suction power (from level 1 to
level 4), press the remote suction button L
on the handgrip at short intervals; the se-
lected suction power level LED indicator will
light up. It is possible to change the power
level both when the suction is on and off. To
switch the vacuum on and off, hold down
the remote suction button L
seconds.
RINSING WITH AIR AND WATER
(only FOAM)
32
• Insert the compressed air fitting hose in V1 (hose
• Adjust the air pressure to the maximum with knob
• Fit the most suitable accessory in the handle
• Connect the device to a suitable electrical
• Start by pressing main switch B.
• Selection switch P1 to the position
• Selection switch P to the position
• For air and water outflow, press lever L3
• Vacuum by pressing button L1.
• To select the suction power (from level 1 to
1
TOPPING UP THE BOILER WATER TANK WITH WA-
TER
• The boiler water tank L supplies the boiler
for about two
1
• When water runs out in the boiler water
AFTER USE
• Every time you finish working, put switch P,
Connect the device to a minimum 5 bar
air compressor (not supplied).
not supplied)
V3.
of the flexible hose L.
outlet.
AIR (II)
H2O (II) water
level 4), press the remote suction button L
on the handgrip at short intervals; the se-
lected suction power level LED indicator will
light up.
through an electronic level control; since this
is an external tank, it can be topped up any
time.
tank:
1. the appliance beeps intermittently
2. the no-water level pilot light C flashes
3. the steam stops coming out
To top up, proceed as follows:
• Switch off the boiler switch E
• Turn off the main switch B
• Remove the cable from the socket
• Fill the boiler water tank J
P1, E, B in OFF position.
EN
1
19