Lavorwash ETNA 4000 Mode D'emploi page 18

EN
STEAM CLEANING
• Fit the most suitable accessory in the handle
of the flexible hose L.
• Connect the device to a suitable electrical
outlet.
• Start vacuuming by pressing main switch B.
Only Foam:
• Selection switch P1 to the steam position
(I).
• Press lever L for steam outflow.
3
• Turn on the steam system using switch E and
wait until "steam ready" light D lights up.
• For the outflow of the steam, press the lever
L . The first amount of steam will come out
3
with water condensation; direct the jet to
one side or onto a cloth.
• Pre-select the amount of steam using the
knob F located on the appliance. The gauge
R indicates the pressure inside the boiler.
• To steam and vacuum simultaneously: it
is possible to use the above-mentioned
steamcleaning functions together.
• To select the suction power (from level 1 to
level 4), press the remote suction button L
on the handgrip at short intervals; the se-
lected suction power level LED indicator will
light up. It is possible to change the power
level both when the suction is on and off. To
switch the vacuum on and off, hold down
the remote suction button L
seconds.
• When work is finished, release the steam le-
ver L a few moments prior to switching off
3
the suction motor L
tion ducts to recover the humidity.
18
for about two
1
. This will allow the suc-
1
STEAM CLEANING + INJECTION HOT WATER OR
DETERGENT
• Fit the most suitable accessory in the handle
of the flexible hose L.
• Connect the device to a suitable electrical
outlet.
• Start vacuuming by pressing main switch B.
• Turn on the steam system using switch E and
wait until "steam ready" light D lights up.
Only Foam:
• Selection switch P1 to the steam position
(I).
• Start injection pump by selection switch P :
H2O (II) hot water or
(I)detergent.
Only Etna:
• To help the primer of the injection pump,
turn the steam tap F off .
• Press the lever L
• Pre-select the amount of steam using the
knob F located on the appliance. The gauge
R indicates the pressure inside the boiler.
• To steam and vacuum simultaneously: it
1
is possible to use the above-mentioned
steamcleaning functions together.
• To select the suction power (from level 1 to
level 4), press the remote suction button L
on the handgrip at short intervals; the se-
lected suction power level LED indicator will
light up. It is possible to change the power
level both when the suction is on and off. To
switch the vacuum on and off, hold down
the remote suction button L
seconds.
• When work is finished, release the steam le-
ver L a few moments prior to switching off
3
the suction motor L
tion ducts to recover the humidity.
3
for about two
1
. This will allow the suc-
1
1