Lavorwash ETNA 4000 Mode D'emploi page 17

TABLE OF USE
Always test on a hidden area of the material.
Car interior: seats
Car interior: floor mats/carpet
Car interior: roof lining/windows
Car interior: dashboard
Car rims
Rugs and carpets in general
Bathrooms, floors, upholstery
Parquet
Stainless steel surfaces
USAGE
STARTING UP
When preparing the appliance for use,
switch it off and unplug it!
- Fill the tank J with water (fig. 1)
Do not put any kind of detergent or chemi-
cal substance in the water tank!
- Fill the tank J with detergent (fig. 2)
1
- Put (◊,+, -,*) hose on (◊,+, -,*) hole on the tank
(fig. 3)
This appliance is designed for use with the
detergent supplied or recommended by the
manufacturer. The use of other detergents
or chemicals may put the appliance's safety
at risk!
- Fit the nozzle H
1
vacuum connection H (fig. 4-5-6)
Never use the appliance without a filter!
of the flexible hose L in the
Normal dirt
foam
vacuum
steam
vacuum
steam/detergent
foam
foam
foam
foam
VACUUMING DUST
• Fit the most suitable accessory in the handle
of the flexible hose L.
- Connect the device to a suitable electrical
outlet.
- Start vacuuming by pressing main switch B.
- To select the suction power (from level 1 to
level 4), press the remote suction button L
on the handgrip at short intervals; the se-
lected suction power level LED indicator will
light up. It is possible to change the power
level both when the suction is on and off. To
switch the vacuum on and off, hold down
the remote suction button L
seconds.
Intense dirt
foam/steam
steam/detergent
steam
vacuum/compressed air
vapore/detergente
foam/steam
steam/detergent
foam
steam/detergent
EN
Drying
vacuum
vacuum
vacuum
cloth
cloth
vacuum
vacuum
vacuum
vacuum
1
for about two
1
17