Application Parameters - IFM Electronic ecomat200 FD-2 Notice D'utilisation

Application parameters

Parameters Description, values, default value
CTx Cycle Time (reset time for output 1/2)
The respective output switches back if within the set reset time no direction-dependent
pulses have been detected.
If the reset time is inactive (0.0 s), the output remains switched according to the last
detected pulse sequence (also see page 21, Operating principle).
CT1 applies to output 1, CT2 to output 2.
• Values: 0.0...1000.0 s
• Default value: 0.0 (no reset time, respective output remains switched)
DTx Delay Time (delay time for output 1/2)
Enables a delayed switching of the outputs 1/2.
The respective output does not switch until the set delay time has elapsed and the
detected pulse sequence continues.
The delay time is only effective for switching, not for switching back the respective
output.
DT1 applies to output 1, DT2 to output 2.
• Values: 0.0...1000.0 s
• Default value: 0.0 (no delay time)
FTx Fleeting Time (fleeting time for output 1/2)
If a pulse sequence is detected, the respective output changes its switching state during
the set time and then switches back to its initial state.
NOTE: It is not useful to activate a fleeting time and the latching function SOx for an
output at the same time.
FT1 applies to output 1, FT2 to output 2.
• Values: 0.0...1000.0 s
• Default value: 0.0 (no fleeting time, output switches statically)
FD-2
MONITOR
page 29