Imetec F2010 Mode D'emploi page 15

ATTENTION! This appliance must only be used with the
control unit supplied. The control unit model is specified on
the label sewn onto the product.
SWITCHING THE THROW BLANKET ON AND SELECTING THE CORRECT TEMPERATURE [Fig. C]
ATTENTION!
or under the sheets when in use.
ATTENTION!
cord on the product.
power cord with the appliance.
• Turn on the throw blanket from the back of the control unit by placing the switch to ON (I)
(10) (Figure [C]).
• RAPID PREHEAT - Press the rapid heating express button (7) to activate the rapid preheating
function of the throw blanket. The relevant symbol
The throw blanket will be pleasantly warm after a few minutes.
• The time required for heating the throw blanket may vary depending on the room's temperature
conditions.
The temperature level of the throw blanket should be judged by placing it on you. Do not assess
the temperature of the throw blanket simply by placing a hand on it because your hands are not
sensitive enough to heat and do not allow you to evaluate the heat required by the body.
• CONTINUOUS USE - If the rapid preheating function is active, press the temperature selector
switch (8) to turn it off.
• The rapid preheating symbol goes off and the last temperature saved will go on simultaneously.
When first used, temperature level 5 will automatically be selected.
• Select the desired temperature setting between 1 and 5 by pressing the temperature selector
switch (8) until the desired temperature lights up in orange on the temperature display (5). The
higher the selected number, the higher the temperature.
• If the control unit is in standby, activate any function by turning off the control unit by setting the
switch in the off position 0 (10) and turn it back on. The control unit will automatically suggest
the last selected temperature. Activate the preheat function by pressing the rapid heating express
button (7).
MEMORY FUNCTION
After a few minutes of use, the throw blanket will save the last temperature selected, which will be
automatically suggested the next time the control unit is switched on.
AUTO SHUT-OFF FUNCTION
The throw blanket has an automatic shut-off system after 1 or 9 hours. When the control unit is switched
on it automatically sets the sleep timer to 1 hour and number 1 lights up on the timer display. Change
the timer by pressing the timer selection switch (6) until number 9 lights up on the timer display.
When the time elapses, the throw blanket will go off and the stand-by display (9) will light up blue.
DISCONNECTION
• Select the OFF position on the back of the control unit (10).
DO NOT place the control unit under the pillow
DO NOT put the control unit and the power
DO NOT cover the control unit and the
lights up in red on the temperature display (5).
EN
13