Batteries; Revival; Selecting Programs - ULTIMATE SPEED ULGD 5.0 C1 Traduction Du Mode D'emploi D'origine

"Err" will be shown briefly in the display. The device
switches to standby.
z 6 V batteries
If a battery is measured in the voltage range 3.7 – 7.3 V,
then you can only select Program 1.
z 12 V batteries
If a battery is identified as being in the critical voltage
range from 7.3 – 10.5 V, then the device will check
whether it is a fully-charged 6 V battery or a discharged
12 V battery. Press the program selector button
a program. The device carries out a test measurement
procedure for approx. 90 seconds. The display will show:
If after approx. 90 seconds, the identified value is
between 7.3 – 7.5 V, then the 12 V is defective.
The device switches to standby.
z Revival
If after approx. 90 seconds, the identified value is between
7.5 – 10.5 V, then a 12 V battery is present. The charging
process starts with pulse operation for revival of the
battery. The voltage display
reached, the device switches to further charging levels.
The revival procedure is identical for all 12 V charging
programs.
z Selecting programs
Note:
If a battery is identified in the voltage range of 3.7 – 7.3 V,
Using the device
flashes. Once 10.5 V is
10
GB/IE/NI/CY/MT
to select
11
21