Hendi 232163 Mode D'emploi page 9

be required to chill in advance the chamber before
starting the positive or negative processes.
5. Cleaning
All the procedures must be carried out with the sta-
tionary unit removing the tension from both the re-
Cleaning of the blast chiller
The maintenance of the blast chiller must include at
least one daily cleaning of the loading zone, in order
to prevent the development and the accumulation of
bacteria.
Before cleaning the blast chiller room, carrying out
the defrosting keeping the door open and removing
the lid of the drainage pipe.
ATTENTION!
It is essential to keep daily clean the blast chiller in
order to prevent the development and the accumu-
lation of bacteria. Before cleaning the chamber of
the blast chiller, you must execute a defrosting pro-
cess, by removing the lid of the drainage basin.
• Do not flush directly the inner parts of the blast
Cleaning the probe
The maintenance of the blast chiller must include
at least one daily cleaning of the temperature core
probe.
It is essential to keep daily clean the blast chiller
room probe. All the procedures must be carried out
with the stationary unit removing the tension from
both the refrigerated item and the condensing unit.
We recommend to rinse carefully the probe with
clean water and with hygienized solution. Refer to
6. Recommendations and warnings
We recommend to make a daily cleaning of the ex-
ternal part of the blast chiller, including the internal
For regulating the functioning parameters consult
the instructions for the instrument panel enclosed
to the current manual.
frigerated item and the condensing unit.
chiller because the electrical parts could get
damaged.
• Do not use any hard metal tools to remove the
ice.
• For the cleaning use only warm water (not hot)
with no-aggressive detergents, taking care of
drying the wet parts with a soft cloth.
• Avoid to use products that contain chlorine or di-
luted solutions, caustic soda, abrasive deter-
gents, muriatic acid, vinegar, bleach or other
products that might scratch or grind.
• We recommend to clean the device at least once
a month, when it used for deep-frozen products.
Attention, during the cleaning operations
it is recommended to use work gloves.
the same methods and detergents for cleaning
named in the previous paragraph.
side of the door near the gaskets.
EN
9