Hendi 232163 Mode D'emploi page 15

There is a 5 seconds lamp-test when the control stats, after that it places in Operative position.
Keys
The front panel stops in stand by functions if the
button "SET" is pressing for 4seconds when the
SET
Time and core probe program setting
Stop - Display
When the time cycle is selected the display shows
the time (in hours and minutes) or the records of the
core probe if the probe cycle is selected.
Stop - Keys
• Set , Up Down
SET
cycle setting.
• Set to go automatically to the negative and
SET
positive probe cycle process.
• Press Set key for 4 sec the control panel is in
SET
stand-by.
Start - Display
The display shows the remaining time (in hours and
minutes), when the time cycle is selected or the re-
cords of the core probe if the probe cycle is select-
ed.
Start - Keys
• Pressing the "SET"
SET
time passed from the starting of the cycle or the
time of the time cycle, in order to reach the cycle
temperature, if it is in conservation modality.
keys permit to enter the
key the display shows the
blasting cycles have been stopped.
The upper point of the second display shows the se-
lection in case of negative process.
• Press Up or Down
cycle if previously was selected the core probe
cycle, otherwise set +/- for the time cycle.
• If the buzzer is on, pressing Down
• Press Start/Stop
If the presence of door is on (PI=I) and the contact is
not well closed, on the display appears "dr" which
shows that the door is open.
• Pressing Up , the temperature recorded by the
room probe is shown. This data lasts 5 seconds.
• If the buzzer is on, pressing Down
• Press Start/Stop
to set automatically time
to turn it off.
to start the cycle.
to turn it off.
to start the cycle.
EN
15