Tunze Comline Reefpack 505 Mode D'emploi page 21

Table des Matières

Publicité

Attachment possibilities with
Universal Holder 3166.250
Attaching Comline to vertical panes
Comline comes with holders and a holding rail
for attachment to vertical panes. By means of the
holding rail, the unit can be secured continuously
at any working position. Use the illustrations to
select the right position for an aquarium with the
corresponding water level. The correct water level
is decisive for the effectiveness and low noise level
of the units.
Pre-mounting the standard holder
Use the lower (front) plastic M5 x 40 mm (1.57 in.)
screw (1) to set the thickness of the glass.
Tighten the M5 x 40 mm (1.57 in.) (2) locking screw.
Set the position of the Comline elements (3). For
this purpose lift the clip; bring the sliding unit into
the requested position, and permit the clip (4) to
snap into place.
Comline needs two holding rails; when using
Reefpack, one with sliding unit (5) has to be fitted to
the filter element, and the other with sliding unit (6)
has to be mounted to the skimmer.
Fixation par support universel 3166.250
Fixation Comline sur vitre verticale
Les composants Comline sont équipés d'une
fixation verticale par attache et rail de réglage.
Ce rail permet un ajustement précis du niveau
d'immersion. En suivant l'illustration, le montage
du support permet de choisir une position de
travail adaptée au niveau d'eau de l'aquarium.
Un niveau d'immersion correct des composants
Comline garantit leur silence et leur efficacité de
fonctionnement.
Montage préalable du support standard.
Ajustez le support à l'épaisseur du verre de
l'aquarium par la vis de réglage plastique inférieure
(avant) M5 x 40mm (1).
Serrez
la
vis
supérieure M5 X 40mm (2).
Ajustez la hauteur de l'élément Comline (3). Pour
cela, maintenez le verrouillage de translation (4),
faites glisser la pièce à la hauteur désirée puis
libérez le verrouillage jusqu'à son enclenchement
dans un des orifices du rail vertical.
Les éléments Comline nécessitent toujours deux
supports. Reefpack nécessite une pièce coulissante
type (5) côté filtre rapide et (6) côté écumeur.
plastique
de
blocage
21

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Comline riverpack 605

Table des Matières