Vermeiren Ceres 3 Mode D'emploi page 12

L
CAUTION:
Risk of pinching - Do not place fingers between the components of the
scooter.
To disassemble, please proceed as follows:

Switch the scooter off.

Remove the armrests from the seat (see "mounting or removing of armrests" chapter).

Remove the seat (see "Adjusting the seat" chapter).

Lift off the rear plastic cover (held in place by Velcro fasteners).
1
To reassemble, please proceed as follows:
1

Loosen the straps used to fasten the
batteries in place.

Unplug all battery plugs (not the pole
connectors) and all cable plug- and socket
connections.

Lift the batteries out.
The chassis - situated below the
seat and armrests can also be
1 = Rear frame
taken apart.
3
2 = Front frame
To remove the front and rear parts
3 = Safety pin
of the chassis from each other:

2

This is difficult to remove. So it
is better to leave these parts
together.

1 = Rear frame
2 = Front frame
3
3 = Safety pin

2

Reconnect the plugs linking the front and
rear parts of the frame (plugs of the same
color go together).

Put the batteries back in and connect to
the battery plugs (plugs of the same color
go together).

Use the straps to tighten the batteries in
such a way that they will not move, even
during drives.

Mount the rear plastic cover.
Page 10
Ceres 3, Ceres 4
2015-03
Pull out the safety pins .
Pull apart the front  and rear
 frames.
Insert the supports of the front
 and rear  frames into each
other in such a way that the
holes for the safety pins  are
aligned.
Push the safety pins  into the
support holes as far as they
can.