Hamilton Beach 40715 Mode D'emploi page 6

How to Use
1
Make sure all three buttons are in the
OFF position (not pushed in) and that the
steam control dial is turned fully clock-
wise to NO STEAM .
5
Holding handle securely, insert filter holder
into brew head with handle pointing left.
Ensure no grounds are on rim of filter holder.
6
2
Fill the removable water reservoir with
desired amount of cold water and
replace securely on the back of unit.
6
Rotate the filter holder to the right until it
is firmly locked into place.
3
Align raised dimple on the exterior of espresso/pod filter holder with cutout notch on
inside of filter holder. Rotate expresso/pod filter holder 180º to secure in base.
Place ground espresso holder into filter holder. Add one tablespoon of ground espresso
for each cup being made. Use shallow holder for 1 cup and deep holder for 2 cups.
Press grounds firmly into holder with tamping tool.
Place pod into filter holder. When using single-serve pod, always use the shallower espresso/
pod filter holder. Never put two pods in either filter holder at one time.
7
Plug in and press ON/OFF button to turn
unit on. When ready, the light next to the
temperature control button will glow green.
OR
4
8
Place one or two cups under brew head
spouts. If using one cup, use one wide
enough to catch espresso from both spouts.