Table des Matières
Publicité
Hand chain pulley block SILVERLINE
English
with spur gear
Before taking into operation, please carefully
read this operating instructions.
Observe the safety instruction!
File documentation!
Destined use
The Hand Chain Block is universally suitable for
lifting and lowering of loads.
The hand chain block is not designed for con-
tinuous operation.
Not suitable for use in explosive danger area.
Not suitable for use in corrosive atmosphere.
Alterations to the winch or fitting of accessories are
only allowed with our written approval.
Pay attention to the technical data and functional
description!
Regulations for the prevention of
accidents
Observe any rules which are valid for the respective
1)
country.
Presently valid in Germany:
BGV D8 winches- lifting and pulling devices
BGR 500 – 2.8 load suspension devices in hoist opera-
tion
DIN 685 part 5
DIN 5684 part 3
EN 818-7
EC regulation 98/37/EC
1)
in the respective version
Safety instructions
Operation,
installation
should only be executed by:
Competent, qualified persons
to IEC 364)
Qualified persons for reasons of their training, experience and
instruction are persons who do their necessary activities
without danger and who can avoid this danger due to their
knowledge of directives, regulations for the prevention of
accidents and standards. These persons are responsible for
the security of the installation.
The Hand chain block must not be used to convey
persons. No persons are allowed to remain within
the hoist's danger zone.
It is prohibited to stand underneath a suspended
load
Never touch moving parts.
Defects must be repaired immediately by competent
trained personnel.
Never leave a suspended load unsupervised.
High-strength parts such as chains, hooks and
transmission components should be kept clear of
free hydrogen, acids, alkalis, vapours and very
aggressive cleaning agents. Risk of brittle failure.
design changes under reserve
!
and
maintenance
work
(definition of experts acc.
F03.01.049
The load
must not be left suspended without supervision,
must not be allowed to swing
The chain
is designed only for the lifting, lowering or pulling
of diverse loads. It should not be used for any
other purpose.
should not be used as slinging tackle.
should not be pulled over sharp edges.
should not be twisted.
should not be extended.
should be regularly tested and serviced in ac-
cordance with DIN 685 Part 5.
The Hand Chain Block
Do not exceed the capacity according to the
technical data.
Before taking into operation, a competent person
must check:
Examinations prior to every use:
brake functions
condition of the chain and load hook (visual in-
spection)
Load lifting tackle
If additional load lifting tackle is used, make sure
its load capacity is sufficient for the job.
Load hooks must have a safety clasp.
Fasten the load correctly.
Do not use the chain as slinging tackle.
Hang the load from the hook in central position
only.
The winch should be given a thorough ex-
amination by a competent person at least once
a year.
Always ensure the maintenance intervals are
adhered to.
Only use original accessories and spare parts;
otherwise safe function is not guaranteed.
page 6
Publicité
Table des Matières
