Tommee Tippee 1149 Mode D'emploi page 6

1. SET UP
Please refer to instructions leaflet before use and remember to clean and descale your unit regularly. It is
recommended to run one cycle of the unit before use. Please refer to the instructions in the Usage section.
2. USAGE
For your childs safety always check milk temperature before feeding by testing on a sensitive part of the skin.
1
Place the unit on a clean, dry kitchen
work surface. Plug unit into the
mains power supply and switch on.
4
Press power button to turn on the unit.
The LED will flash and beep once to
show the unit is in standby mode.
7
Select volume of food - press until the
LED is adjacent to the amount of food
to be warmed.
2
Place the easy lift cradle into the unit
and add 250ml/9floz of water using
your Tommee Tippee bottle.
5
Select bottle type - press until the
LED is adjacent to your requirement.
8
Press the power button, the unit will beep once to show the cycle has started.
When the cycle finishes the unit will beep 3 times, and LEDs will keep flashing
while the food is still warm. Pressing any button will stop the LED flashing, or it will
automatically switch off after 45mins.
3
Lift the easy lift cradle and place in
the bottle or pouch. For hygiene we
recommend leaving the hood on
the nipple.
6
Select starting temperature - press
until the LED is adjacent to the
correct temperature of food.
Remove food after the
9
cycle is completed taking
care not to touch the water inside
the unit as it will have heated during
the cycle. Empty unit and wipe dry
with a clean cloth.
TO RESET/SWITCH OFF
To cancel a cycle - hold down the
power button for 3 seconds and the
unit will reset.