aldes C.Axpir Initia Notice D'installation page 12

EN
Leave sufficient space for the central unit around the wall bracket.
Install the wall bracket onto the surface of the wall panel. The installation wall of the
wall bracket must be straight. Use a spirit level to ensure this. If necessary, the wall
can be straightened using an additional installation panel.
Leave sufficient margins on the low voltage wires.
Tip for easier installation:
If the central unit is to be installed in a narrow
closet, attach the pipe elbows to the inner part
of the wall bracket before installing the inner
part on the wall.
1. Make sure that the input and output sides of the piping leading to the central unit
are on the correct sides of the wall bracket.
The inner part of the wall bracket can be installed either way around.
2. Align the inner part of the wall bracket vertically on the wall, with a maximum
deviation of +-5 degrees.
3. Attach the inner part of the wall bracket securely to the wall structure with
screws (4,2x50 mm TX20). Use the wall plug if necessary (wall plug 6 x 30).
12
INSTALLATION OF THE WALL BRACKET
Series A (mm)
C.Axpir Initia 479
C.Axpir Comfort 684