Charging Method - Hitachi P 20DA Mode D'emploi Et Instructions De Securite

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Rechargeable
battery
Insert
d
Fig. 5
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 5. Make sure it contacts the
bottom of the battery charger.
CAUTION:
If the batteries are inserted in the reverse direction, not only recharging will become
impossible, but it may also cause problems in the charger such as a deformed recharging
terminal.
3. Charging
When the battery is connected to the battery charger, charging will commence and the
pilot lamp will light in red. (See Table 2)
NOTE: If the pilot lamp flikers in red, pull out the plug from the receptacle and check if
the battery is properly mounted.
When the battery is fully charged, the pilot lamp will bilink in red slowly. (At 1-second
intervals) (See Table 2)
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
Hole for connecting
the rechargeable
battery
Pilot lamp
1. Insert the plug of battery charger into
the receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
WARNING:
English
Do not use the electrical
cord if damaged. Have it
repaired immediately.
13