Ebode VLHD38 Guide Utilisateur page 9

4.4 Transmitter Connection (Source Location)
1. Please connect the VLHD38 Transmitter Power via the included Power adapter or the
included USB power cable** before you make the below connection.
(** Please note that when using power from USB the USB port needs to deliver a
minimum of 1.5A. If the USB port has less than 1.5A you could damage the USB port or
a connection could not be established)
2. The VLHD38 Transmitter can also send IR from the VLHD38 Receiver (remote
location) back to the Source to control it. Please go to step 3. if you don't need IR
control from the remote location.
Plug the IR extender into IR OUT and place the IR Emitter on the IR Receiver window of
your source.
HINT: If you can't find the IR Receiver window on your source, use a flashlight or the
Flashlight of your mobile phone to find the IR Receiver window.
30-1-2015 9 ebode VLHD38