Sample Of Use; Ebode Vlhd38 - Ebode VLHD38 Guide Utilisateur

No sound
or bad
sound
Register
failure
Connectio
n failure
Other
problems
In case of any other problems, please read the frequently asked questions in part 5 first.
If this cannot help you to solve the problem, please visit our website and go to the FAQ
section. If there are any product firmware updates available they can be found on our
website www.ebodeelectronics.eu.
5.

Sample of use

30-1-2015
1. Make sure the source equipment output support audio format.
2. Restart the transmitter and connect it again.
3. Make sure there is no disturbance from the same frequency
(4.9～5.9GHz) within 50cm (Wi-Fi modem, microwave etc.)
1.Ensure the distance between transmitter and receiver doesn't
exceed supported distance. If it does, make them closer and try
it again.
2.Check if source device has been added on display equipment.
If it has, delete it and make registration again.
1 Ensure the working distance doesn't exceed supported distance.
If it does, make them closer and try it again.
2 Make sure source devices have been registered every time after
software update.
3 Ensure source devices and display devices have been registered.
4 If failure occurs again, delete all registered information and try
again.
5 When using the USB Power cables, make sure that the USB port
delivers sufficient Power. A minimum of 5V 1.5 Amp is required
to power the VLHD38. Please refer to the USB output device
manual to find out how much power the USB port can deliver.
Please also note that if a port delivers 1.5 Amp, and the USB port
is shared (example 3 ports), the output can be lower than 1.5
Amp when a second and/or third USB device is connected. We
recommend to test with the included Power adapters first. After a
successful connection, switch to USB Power cables (Receiver side
first) and retry.
If any other problems occur, please un-power all connected
devices and check again.
13

ebode VLHD38