Frequently Asked Questions - Ebode VLHD38 Guide Utilisateur

USB Optional: Connect a compatible USB mouse, keyboard, gamepad to the receiver
through USB interface and make sure they are perfectly connected. HINT: if the USB
device is not working, disconnect the USB device and establish a video connection first.
After the video connection is successful established, re-connect the USB cables.
4.6 Pair devices:
The VLHD38 should automatically connect when:
 Both the VLHD38 Transmitter`s Power Buttons are ON
 The source is connected, powered and playing / showing image
 The TV on both Transmitter and Receiver side are Powered, ON and set to the right
input channel for HDMI (depends on where the VLHD38 is connected)
 All cables are connected properly
 30 seconds have been passed (the VLHD38 needs to boot)
 If USB Power has been used; has enough output power (minimum 1.5A)
If the VLHD38 connection fails:
 Press the PAIR button on the VLHD38 Transmitter
 Press the PAIR button on the VLHD38 Receiver
After pairing, the connection is re-established and the system is ready to transport AV
signal. The Receiver TV will show its status (connecting, searching etc.)
In case you have no signal we suggest you to check chapter 5 (Frequently asked
questions) and to find out what has gone wrong.
5.

Frequently Asked Questions

Before following the frequently asked questions below, make sure that your receiver and
attached equipment (HD source and display) are all properly connected, switched on and
not in Standby Mode, please give them a 10 second power off reset before taking the
next steps:
No video
Power
LED off
Receiver
video
indicating
LED
abnormal
Bad
picture
30-1-2015
1. Are the VLHD38 Power Buttons on both the Transmitter and
Receiver ON?
2. Ensure there is video on the output device (Source).
3. Check the
equipment.
4. Make sure all devices are working on supported distance. Draw
them closer and try it again.
5. Is the VLHD38 USB Power Cables are used, make sure there is
enough output power on the USB Power Port (1.5A Minimum).
1. Make sure the Power Adaptor or Power USB cable is correctly
connected and the voltage is 5V 1.5A or higher.
2. Make sure the power supply would not be interrupted.
1. Make sure video and audio signals can be transmitted to receiver
successfully.
2. If there are video and audio signal on output devices, please
check the indicating LED to see if something got wrong with it.
3. Make sure the device is working within the supported distance.
1. Ensure there is video on output devices.
2. Check if the receiver is correctly connected to display equipment
and there is no damage on joints and wires.
3. Make sure all devices are working on supported distance. Draw
them closer and try it again.
receiver is correctly
12
connected to display
ebode VLHD38