Pando I-1001 Instructions De Montage page 7

TECHNICAL DIVISION
1‐ Protect the cooktop.
Raise the upper section of the
structure to the ceiling and mark the
holes.
Drill the holes and fit plugs.
5‐ Secure the guides with the 4 screws supplied.
6‐ Connect the extraction tube and mains cable.
(Note: Make sure the power supply to the cables is disconnected when
making the connection)
NOTE: THE HOOD MUST BE CENTRED OVER THE COOKING AREA
2‐ Screw the upper section to the
ceiling, with the extraction tube and
mains cables inside.
Adjustment screw
Adjustment screw
ASSEMBLY MANUAL I‐1001
3‐ Raise the hood assembly and lower
structure to the level of the upper
structure.
4‐ Slide the structure along the guides
until the hood is 65 cm above the
cooktop.
8‐ Fit the upper tube which is
composed of 2 parts and screw it to
the structure with the screws
supplied.