Cleaning - Atag CU1050SMR Notice D'utilisation

MAINTENANCE

Cleaning

Attention!
For all maintenance first switch off the mains power to the built in unit
by pulling the plug out of the socket or by turning off the home's master
switch.
The built in unit needs to be cleaned regularly, both inside as well as
outside. Do not use abrasive cleaners. Do not use alcohol!
Attention!
If the instructions regarding cleaning the appliance or replacing the
filters are not followed, this can cause a fire. These instructions should
be followed! The manufacturer is not liable for damage to the built in
unit or fire damage resulting from incompetent maintenance or from
non-adherence to the recommendations above and delivered safety
instructions.
Clean the built in unit with soapy water and a soft cloth. Then wash
off with clean water. Do not use aggressive cleaning agents such as
caustic soda and do not use scouring pads. Finish with a non-abrasive,
non-polishing agent and buff the stainless steel in the direction of the
grain.
Metal grease filters
These must be cleaned once a month (or when indicated by the filter
saturation indication system, if present on your model) using non-
aggressive detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle. The openings must be
placed downwards to let the water run out of the filters. When washed
in a dishwasher, aluminium grease filters may be discoloured slightly.
This is normal and does not affect their filtering capacity.
The degree of saturation of the filter depends on the intensity of use,
the manner of cooking and the regularity with which the grease filters
are cleaned.
EN 9