Installation Of The Smoke Detector - HumanTechnik lisa Mode D'emploi

7. Installation of the smoke detector

In order to avoid injuries or damage, the device must be reliably fixed to
the ceiling in accordance with this instruction.
Installation with screws and wall plugs:
Use the supplied fixing material for installation of the smoke detector. If
other screws are used, these must not project into the base more than
5 mm. The mounting surface must be even! The small self-adhesive
area serves only to find the position for the base and is not intended
to hold the smoke detector!
1. Hold the base to the desired location. Mark the positions of both holes.
2. Drill the holes with an according drill.
3. Push a plug into each hole.
4. Screw the base lightly to the surface, hold the base in place and tighten
the screws - but not too much.
5. Insert the detector into the base, with the markings in alignment.
6. Turn the detector clockwise until the detector clicks into its final
position. The detector automatically switches on.
40