Table Des Matières; Meanings Of Symbols; Before Using Your Machine; What Is What - Tanaka TCH 22EAP 50 ST Mode D'emploi

English

MEANINGS OF SYMBOLS

NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their
meaning before use.
It is important that you read, fully
understand and observe the following
safety precautions and warnings. Careless
or improper use of the unit may cause
serious or fatal injury.
Read, understand and follow all warnings
and instructions in this manual and on the
unit.
Contents
WHAT IS WHAT? ................................................... 2
WARNINGS AND SAFETY INSTRUCTIONS ......... 3

WHAT IS WHAT?

Since this manual covers several models, there may
be some diff erence between these illustrations and
your unit. Use the instructions that apply to your unit.
1. Recoil starter
2. Fuel tank
3. Throttle lever lockout
4. Throttle lever
5. Front handle
6. Rear handle
7. Spark plug
8. Hand guard
9. Cutting blade
10. Air cleaner
11. Stop switch
12. Blade guard
13. Gear case
14. Choke lever
15. Lock lever
16. Priming pump
17. Blade case
18. Combi box spanner
19. Handling instructions
2
Always wear eye, head and ear protectors
when using this unit.

Before using your machine

• Read the manual carefully.
• Check that the cutting equipment is
correctly assembled and adjusted.
• Start the unit and check the carburetor
adjustment. See "MAINTENANCE".
SPECIFICATIONS .................................................. 5
OPERATING PROCEDURES ................................. 5
MAINTENANCE ..................................................... 7
1
11
3
6
15
4
7
TCH22EAP (50ST), TCH22EBP (62ST)
TCH22ECP (62ST), TCH22ECP (78ST)
17
5
16
8
9
14 12
10
2
13
19
18