Contents; Technical Information; Notes About Using This Model For The First Time; Preparations - marklin 29730 Notice D'utilisation

• Do not bend the USB charging cable included
with this set. Check it regularly for damage to
the cord, plug, enclosure and other parts, and
in the event of such damage, they must not be
used until the damage has been repaired.
• Do not store or use locomotive, cars and com-
ponents in water or a moist environment.
• Do not add components made of metal or of
electrically conductive material.
• Avoid short circuits.
• Do not throw 4x4 Mobile Power Plus STAX onto
hard surface.
• Never throw 4x4 Mobile Power Plus STAX into a
fire and don't store them in a hot location.
• Please store 4x4 Mobile Power Plus STAX in a
fire protected location, such as a metal box, if
not being used for a long time.
• See Section 12 about disposing of rechargeable
batteries.

3. Contents

3-part train (Building Kits):
- Building Blocks
- 4x4 Mobile Power Plus STAX
- Sound STAX (Sound Building Block)
- 1 Recharging cable (USB / micro USB)
- Decals
12 no. 24130 sections curved C Track
1 no. 24188 sections straight C Track 188 mm
1 Basistation C Track 188 mm
2 no. 24172 sections straight C Track 172 mm
1 no. 66201 switched power pack
1 IR Controller
2 type AAA/LR 03 1.5 volt batteries
Operating instructions
Operating instructions
Building Instructions for Locomotive and Cars
Warranty card

4. Technical Information

Switched power pack:
Voltage supply train:
Power consumption of train
H0 Gauge (1:87 scale)
4.1 Overload Protection
A built-in overload protection protects the switched
power pack from damage in the event of an overload
or a short circuit. All lokomotives will be stopped.
See also point 10.
D NL
GB F
DK
S
input 230 volts AC
output 18 volts DC/18 VA
max 22 volts DC
max 13 VA
5. Notes about Using this Model for
the First Time
• The switched power pack may not be plugged
into the wall outlet yet.
• The locomotive and cars are building kits and
must be assembled from individual building
blocks (see enclosed „Building Instructions for
Locomotive and Cars").

6. Preparations

6.1 4x4 Mobile Power Plus STAX
Micro-USB-Port
Note: One Power STAX can supply light to over
500 Light STAX Building Blocks.
6.2 Charging the 4x4 Mobile Power Plus
STAX
1. Connect the micro USB side of the Power Cable
to the 4x4 Mobile Power Plus STAX.
2. The USB plug for the charging cable included
with this set may only be connected to a
charging device from Protection Class II
(example: from a cell phone charger), which is
provided with the following symbol:
3. The logo button flashes red (Battery Charging).
4. Button turns from red to green (Battery if fully
Charged).
5. The button will ALWAYS remain green when
battery is fully charged and USB Power Cable
connected.
For Mobile Use: Disconnect the USB Power Cable
from the USB power source and the 4x4 Mobile
Power Plus STAX.
Button
Built-in microphone
11