For Your Safety; Standard Equipment - Viking ACK 050 Manuel D'utilisation

Mowing blades ACK 050 and ACK 055
The mowing blades ACK 050 and
ACK 055 replace the standard multi-
blades of the Series 6 lawn mowers.
Grass catching performance is improved
and filling of the grass catcher box
optimised when using the lawn mower as
a grass collector.
This instruction manual constitutes
original manufacturer's instructions in
the sense of EC Directive 2006/42/EC.
VIKING is continually striving to further
develop its range of products; we therefore
reserve the right to make alterations to the
form, technical specifications and
equipment level of our standard
equipment.
For this reason, the information and
illustrations in this manual are subject to
alterations.
This instruction manual is protected by
copyright. All rights reserved, especially
the right of reproduction, translation and
processing using electronic systems.

1. For your safety

Observe the instruction manual of the lawn
mower, particularly the "For your safety"
and "Maintenance" sections. The
instructions for blade maintenance must
always be observed.
Detach the spark plug socket before
performing any work on the lawn mower.
Before each use, perform a visual check to
ensure that the mowing blade and blade
fastening are in good condition.
0478 909 9922 A - EN
The mowing blade ACK 050 is only
suitable for the following lawn mowers:
MB 650.3 T, MB 650.3 V, MB 650.3 VS
The mowing blade ACK 055 is only
suitable for the following lawn mowers:
MB 655.3 V, MB 655.3 VS, MB 655.3 YS
The mowing blades ACK 050 and
ACK 055 must only be used without the
mulch insert.
Risk of death from suffocation!
Packaging material is not a toy -
danger of suffocation! Keep
packaging material away from
children.

2. Standard equipment

Item Designation
A Mowing blade
B Retaining washer
C Hexagon screw M10x40
D Hexagon screw 3.8"x85
– Instruction manual
3. Assembly
3.1 Installing and removing the
mowing blade
● Remove the mulch insert and tilt
the lawn mower upwards into the
cleaning position (see the instruction
manual for the lawn mower).
Printed on chlorine-free bleached paper. Paper is recyclable. Cover is halogen free.
● Remove the multi-blade installed as
standard as per the instruction manual
for the lawn mower. Discard the blade
fastening screw and retaining washer.
1 Installing the mowing blade:
Risk of injury!
The mowing blade (A) must only be
installed as shown. The tabs (1)
must face downwards and the
curved wings must point upwards.
Observe the specified torque when
tightening the blade fastening
screw, as the secure attachment of
the cutting tool depends on this.
Additionally secure the blade
fastening screw (C or D) with
Loctite 243.
Replace the retaining washer (B)
each time the blade is installed and
the blade fastening screw (C or D)
1
each time the blade is replaced.
Qty.
● Clean the blade contact surface and
1
blade bushing or blade holder.
1
● Position mowing blade (A) on blade
1
holder (2) or blade bushing (3) with the
1
curved wings pointing upwards.
1
● MB 650 VS, MB 655 VS, MB 655 YS:
Use screw (C)
MB 650 T, MB 650 V, MB 655 V:
Use screw (D)
● Position retaining washer (B) as
illustrated and screw in and tighten
blade fastening screw (C or D).
2
Tightening torque:
60 - 65 Nm
2 Removing the mowing blade:
● Hold mowing blade (A) and unscrew
blade fastening screw (C or D).
5