Publicité
Les langues disponibles
Les langues disponibles
6.0 Troubleshooting
The motor does not run
The overload protection has responded
Set the reversing switch to position B and press the reset button, keep the on/off switch pressed to switch on
the shredder for a short period. After the blocking has been removed, reset the reversing switch to position A.
Power failure
Check the power supply cord, the plug and your house connection fuse and RCD.
Safety switch on the collection box not locked in position
Ensure collection box is in position and locked.
The material to be chopped is not pulled in
The chopping knife is running backwards.
Change the direction of rotation.
The material is jammed in the feeding funnel
Set the reversing switch to position B and switch on the shredder. Pull the material from the feeding funnel.
Re-feed thick branches such that the chopping knife does not immediately grasp the pre-cut notches again.
The cutting blade is blocked
Set the reversing switch to position B and switch on the shredder The chopping knife will now run backwards to
release the blocked-up material.
Caution! Change the direction of rotation to the desired position after the shredder has come to a complete
standstill.
7.0 Maintenance and Storage
Take care of your machine and clean it regularly to obtain long-lasting efficiency and performance.
Keep the air vents clean and free from dust.
Use only a warm damp cloth and a soft brush to clean your machine.
Never wet or spray water on the machine.
Do not use any detergents or solvents as these could cause irreparable damage to your machine. Chemicals
can destroy the plastic parts.
The tightness of the fastening screws of the undercarriage should be checked from time to time.
To protect the shredder from corrosion when storing it for a longer period, treat the chopping knife with some
ecological oil.
When the machine is stopped for servicing, inspection, or storage, or to change any accessories, shut off the
motor, unplug the connection cable (to disconnect the electric unit from the power supply), make sure
that all moving parts have come to complete stop. Allow the machine to cool down before making any
inspections, adjustments, etc.
Store the machine in a dry place. For extended storage periods, run the unit dry for a short time. Always allow
the machine to cool down before storing it.
When servicing the chopping knife assembly be aware that, even though the motor will not start due to the
interlock feature of the guard, the chopping knife assembly can still be moved by a manual starting mechanism.
2
Publicité
