Publicité
Les langues disponibles
Les langues disponibles
Warning! Read this first.
Warning! Please read and follow the safety
instructions carefully before using the unit.
Warning! In case of damage to the power
cord, it must be replaced by the manufacturer,
repairer or any qualified person authorized to
prevent electric shock.
During operation, do not reach into the
chute assembly 8. The machine runs on for
a few seconds after being switched off.
Never allow children or people unfamiliar
with these instructions to use the ma-
chine. Local regulations may restrict the
age of the operator. When not in use store
the machine out of reach of children.
This tool is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a per-
son responsible for their safety.
Children should be supervised to ensure
that they do not play with the appliance.
Before switching on, the machine must be
assembled according to the enclosed in-
structions.
It is recommended for increased electrical
safety to use a Residual Current Device
(RCD) with a tripping current of not more
than 30 mA. Always check your RCD every
time you use it.
Use only extension cables that are intend-
ed for outdoor use and are protected
against splashes of water.
Do not touch the plug or socket with wet
hands.
Do not run over, crush or pull the power
supply cable or extension lead, otherwise
it may be damaged. Protect the cable from
heat, oil and sharp edges.
Other persons and animals should remain
SAFETY
at a distance of 3 metres or more when the
machine is being used. The operator is re-
sponsible for third persons in the working
area.
GARDEO can assure flawless functioning of
the machine only when original accesso-
ries are used.
Become familiar with the instruction man-
ual before attempting to operate this ma-
chine.
Avoid wearing loose-fitting clothing, hang-
ing cords or ties.
Only operate the machine in open space
(e. g. not too close to a wall or other fixed
objects) and on a firm, level surface.
Do not operate the machine on paved or
gravel surface where ejected material
could cause injury.
Before starting the machine, check that all
screws, nuts, bolts and other fasteners are
properly secured and that guards and
screens are in place. Replace damaged or
unreadable warning and operating labels.
Before starting the machine, make certain
that the chute assembly is empty.
Keep your face and body away from the
chute assembly.
Do not allow hands or any other part of the
body or clothing inside the chute assembly,
discharge chute or near any moving part.
Keep proper balance and footing at all
times. Do not overreach. Never stand at a
higher level than the base of the machine
when feeding material.
Always stand clear of the discharge zone
when operating the machine.
When feeding material into the machine be
extremely careful that pieces of metal,
rocks, bottles, cans or other foreign ob-
jects are not included.
If the cutting mechanism strikes any for-
eign object or if the machine should start
making any unusual noise or vibration, im-
1
Publicité
